Build the screen the job needs: workbooks, templates and Compare by
Every Muretto page is a workbook you lay out yourself. How to build sheets that answer one question each, save them as templates, and group laps by stint, driver or setup.
Scorsa Team3 min read

Most telemetry tools give you one screen and ask you to fit your questions into it. In Muretto every page is a workbook: a set of worksheets, each laid out however you like. This post covers how to build them well.
One sheet, one question
The most useful workbooks are made of sheets that each answer a single question. "Where am I losing time to my reference?" is a sheet. "Is the car balanced in the fast corners?" is another. "Will we make it to the flag on this fuel?" is a third.
When a sheet tries to answer everything it ends up answering nothing, because nobody knows where to look.
Adding panels
Open Add Display and you will find over ninety ready-made displays, grouped by when you need them: live wall, strategy, driving analysis, vehicle and reports. Each one answers one question, already set up.
There are also blank panels: a chart, a map, a table, a gauge, an X-Y plot, a histogram and more. Point a blank panel at any channel, including your own math channels, and it becomes whatever you need.
Then arrange them:
- Split, drag and resize panels to build the layout.
- Open Properties on any panel to change its channels, scales and statistics.
- Pop out a panel into its own window to put it on another screen.
- Use the command palette and keyboard shortcuts to switch between sheets quickly.
Start from a built-in workbook
You do not have to start from nothing. Muretto ships an Engineer workbook of ten sheets and a Driver workbook of four, plus saved pages for Strategy, Race Engineer, Coach, Lap Analysis, Overlay, Lap Report, Stints, Fuel, Tyres, Engine and Setup.
Open one, change what does not suit you, and keep the rest.
Save it as a template
Once a sheet works, save it. You can save one sheet, or every tab at once, as a template. Keep it in your account, export it to a file, or publish it to the gallery.
This is what makes a programme consistent. When every engineer opens the same template on every session, the data is read the same way by everyone, and a debrief does not start with ten minutes of "which channel is that?".
Templates also carry the math channels they use. If a sheet plots a channel you wrote yourself, the channel travels with the template, along with any other math channels it reads. Whoever opens it gets a sheet that draws, not empty lanes. If they already have a channel of the same name, theirs is kept.
Compare by
Picking laps one by one works for two or three laps. For a whole session, use Compare by to group laps by stint, run, driver or setup. Every table and trend on the page follows the grouping.
Some questions this answers in one click:
- Did the second stint fall off more than the first?
- Which driver is quicker in the middle sector, on average, not on their single best lap?
- Did the setup change we made at lunch actually do anything?
Car profiles: one workbook, many cars
Every logger names its channels differently. One calls it Ground Speed, another vCar, another GPS_Speed. Muretto's car profiles map each car's and each logger's channel names onto one standard set, in standard units.
That is why a workbook built once works across a GT3 in iRacing, a MoTeC file from a real car and a VBOX file from a track day. Your sheets and your math channels refer to [Speed], [Throttle] and [Brake Pres], and the profile does the translating.
Next
The panels show channels. The next post shows how to make your own: an introduction to math channels and the expression language behind them.